Enable and configure indoor mode on a map

If you have the indoor feature and your map contains building plans / levels / booths..., you must enable indoor mode to be able to configure it from Wemap Pro.

🗺️ Associate the generic indoor stylesheet

1. Access your map
2. Go to the "Styling" menu
3. In the "Map Style" section, select "Generic Style"

🏠 Enable indoor mode

1. Access your map
2. Go to the "Indoor" menu, at the bottom left
3. Click on "Enable indoor mode" (by default, it is disabled)

A list of settings appears below.

⚙️ Configure settings

• Use indoor markers: enable or disable the option
  • If enabled: the map displays the markers / pinpoints integrated into your map's stylesheet  
  • If disabled: the map uses the outdoor markers / pinpoints from the livemap (those belonging to the list you associate with the map)
• Minimum zoom for indoor mode:
  • Specify the zoom level from which the map will display the level selector associated with the building (by default, it is set to 17)
  • When a floor is selected, a filter is applied to display the elements of that floor
• Search points on active level: enable or disable the option
  • If enabled: the user can only search for points located on the currently displayed level
  • If disabled: the search applies to all levels
• Floor for outdoor points: specify a floor number on which outdoor points will be displayed (by default, without information, outdoor points will be displayed on all floors)
• Enable highlight on click / hover: enable or disable the option
  • If enabled: a highlight style is applied to the points affected by the click
  • If disabled: no style is applied
• Enable highlight on search (only appears if highlight on click / hover is enabled): enable or disable the option
  • If enabled: activates highlight during a search
  • If disabled: no highlight is performed during a search